StewMac 57 MINI TWEED, Assembly Instructions Manual

Page: 15 / 40

stewmac.com
13
© 2018 StewMac
STEP 18
Add the power cord + strain relief
Strip away the power cord’s outer
insulation to reveal 7-1/2" of the three
leads inside .
Trim the black lead to 5" .
Trim the green lead to 3" .
Leave the white lead 7-1/2" long .
Pull the power cord leads through the
hole in the chassis and secure with the
black strain relief .
The strain relief is a tight fit . Use pliers
to squeeze it onto the power cord out-
side the chassis, and keep squeezing
to fit it into the mount hole .
STEP 19
Install the fuse socket
Mount the fuse socket so its side lug
is facing the open side of the chassis .
This makes it easier to solder later .
STEP 20
Install the pilot lamp socket
Mount the socket by screwing the
lens from the outside into the socket
assembly . Turn the arm supporting
the lamp toward the fuse .
STEP 21
Install the volume pot
A small metal tab protrudes from the
face of the pot . Bend and snap this
off, so the pot can mount flush to the
surface of the chassis .
Mount the pot so its three lugs face
out toward the chassis opening .
STEP 22
Install two jacks + 1M resistor
Add the two input jacks . Turn the
jacks so the right lug of jack 1 is close
to the center lug of jack 2 as pictured .
Run one lead of the 1M resistor
through the right lug of jack 1 and
through the center lug of jack 2 .
Make sure the lead won’t be in the
way when an instrument cable is
plugged in .
This resistor connects to all three
lugs of jack 1 . Run the resistor’s other
lead through the left lug of jack 1 and
connect it to the center lug of jack 1 .
Don’t solder these connections yet .
5Y3 6V6 12AX7 SPEAKER JACK
JACK 1 VOLUME POT LAMP FUSE JACK 2
4
3
2
1
8
7
6
5
6
4 3 2
1
9 8
7
5
4
3
2
1
8
7
6
5
LEFT + RIGHT
refer to however
the parts are
shown on the
diagram
RIGHT LEFT