Stewart Golf Q Series, Owner'S Manual

Page: 6 / 11

10 11
HANDSET GUIDE
Your Q Follow is supplied with a rechargeable Bluetooth handset. The handset is
supplied paired to your machine and cannot be used with any other.
1. Forward/speed up.
2. Indicator light.
3. Left & right turn.
4. STOP. Use as primary stopping function.
5. Slow down/reverse.
6. Glide Stop. Also see notes on glide steering.
7. Cruise Control speeds.
8. Follow.
9. Bluetooth ON/OFF. Press & hold for one second to turn on. When turning off, a red
light shows momentarily.
In normal use, the indicator light will be blue:
LIGHT OFF: Handset is switched off.
LIGHT FLASHING:
Handset is on, but not connected to the machine.
LIGHT ON: Handset is on and connection has been established.
WARNING
NEVER
open the handset
unless you have been
instructed to do so by our
support team. Always ensure
you are electrically earthed/
grounded to avoid damaging
the internal components of the
handset.
The handset may only be
opened to replace the lithium
battery within.
HANDSET CHARGING GUIDE
The lithium battery inside the handset is large enough for two rounds of golf, but
it should be charged after every round to ensure sufficient power.
Always charge the handset indoors and at room temperature, observing the same ‘DO
and DO NOT’ advice shown on page 9. The charging process can take up to six hours.
1. Ensure the handset is switched off and the indicator light is off.
2. Remove the protective silicone skin.
3. Expose the charging port on the side of the handset by pulling out the black plug.
4. Connect the USB power cable to any 5V USB power outlet.
5. Connect the USB power cable to the handset & switch on power (if applicable).
6. The indicator light on the handset will show
RED while charging, and GREEN when
fully charged.
7. Once the indicator light is GREEN , disconnect the power cable from the handset.
8. Return the black plug to the charging port on the side of the handset, then refit the
protective silicone skin.
HANDSET CARE
Using the handset skin and charging port plug means that the handset will be
showerproof (it is not waterproof). Water and electronics are natural enemies and you
must take care to make sure no water ever gets inside the handset.
• Never allow the handset to be immersed in water and don’t wash it.
• If you want to wash the silicone skin, remove it from the handset before washing it,
then dry it thoroughly before replacing it.
• If you use the handset in the rain or other wet conditions, remove the silicone skin
as soon as you have finished playing and wipe both handset and silicone skin dry to
remove any moisture that may have found its way down the edges of the silicone
skin. Allow both to dry fully before refitting the silicone skin.
• Don’t store the handset anywhere that water or moisture might get into it.
• Refer to the
DO and DO NOT guide on page 9 for further advice on how to care for
the handset and lithium battery contained within.
LONG TERM STORAGE
If you are not going to use your Q Follow for more than one month, the handset should
be put through a charge cycle at least once every month.
This will avoid the handset battery being completely discharged.
Prior to using the handset again it should be fully charged.
WARNING
The handset should only be charged with the supplied USB power cable. Using
any other cable or power source can damage internal components: this will not
be covered under warranty.
1
2
3
3
4
5
6
7
7
8
9