Stewart Filmscreen
– Visionary
5
ABOUT VISIONARY
The Visionary is designed for ease of installation. The case can be installed separately during
construction, and the screen assembly is then installed once the construction is completed. The
Visionary features a seamless, self-finishing face-plate and drywall stops to accommodate various
ceiling configurations.
IMPORTANT SAFETY INFORMATION
Carefully read the instructions.
This screen must be installed by a qualified electrician.
For supply connections, use wires rated for at least 75 C.
Use copper or aluminum conductors.
For indoor use only.
Do not connect low voltage to line voltage power.
Earth ground terminal connection must be made as shown in wiring diagrams.
Proper short circuit and overload protection must be provided at the circuit breaker distribution
panel. You may use up to a 20 amp maximum circuit breaker with adequate short circuit breaking
capacity for your installation.
USING THIS MANUAL FOR INSTALLATION
If you are using this manual to install the Visionary screen, you should be aware that the factory
advises against installing a concealed or recessed electrical projection screen permanently. You
must be able to access and remove the unit should future service be necessary.
For the instructions related to your specific controls, refer to the appropriate page:
IMC (see Page 12)
LVC (see Page 15)
HVS (see Page 18)
VICS (see Page 19)
⚠
NOTE
This
owner’s manual may describe options and features not equipped to the specific
screen you have purchased.
