Page 7
EFFECTS CONTENT
APPLY EFFECTS TO YOUR MESSAGE
Now let’s customize a new message using the effects that fit your preference.
Enter the Edit Mode
1)
Press [MENU].
2)
Press [OK] twice.
Input the phrase “Stewart Signs”
3)
Use the designated Character/Number buttons to input the phrase “Stewart Signs”.
4)
When your message is complete, press [OK].
Insertion Effect – The effect used to control how your message will jump on the display.
14)
Use the or arrow buttons to scroll through the categories.
NOTE:
Press [OK] to preview the effect with your message. Press [ESC] to go
back to the effects selection menu.
TIP:
When previewing an effect, try using the or arrow buttons to see a
variation of the selected effect. Also try using the or arrow buttons to
manipulate the speed of the effect.
15)
When you are satisfied with your effect preview, press [OK].
Preservation Effect – The effect used when your message is stationary on the display.
16)
Use the or arrow buttons to scroll through the effects.
17)
When you are satisfied with your effect preview, press [OK].
Hold Time – How long your message will remain on the display before Release Effect.
18)
Use the or arrow buttons to select a number from 01 – 99.
19)
Use the or arrow buttons to select between seconds [S] or minutes [M].
20)
When you are satisfied with your setting, press [OK].
Release Effect – The effect used to remove your message from the display.
21)
Use the or arrow buttons to scroll through the effects.
22)
When you are satisfied with your effect preview, press [OK].
NOTE:
Refer to the Appendix Section for a list of all effects.
Connection – This setting has no function at this time.
23)
Press [OK].
Run your message
24)
Press [ESC] to run your message.
[ ]
[ ]
[ ]
[ ]
[ ]
[ ]
[ ]
[ ]
[ ]
[ ]
[ ]
[ ]
[ ]
[ ]
