AV30MX-2 Operations Manual Rev C
Page 7
Table of Contents
Top
6
Controls and Indicators
1.
Speaker output connector (refer to Section 5.3.5)
2.
Remote mute connector.
Note that +5VDC to +10VDC is required to mute the amplifier.
3.
Power connector (3.5mm): connect power adapter supplied with unit only.
Be careful not to
insert this connector into the Mute connector location!
4.
Input 2 level control.
5.
Input 1 level control
6.
Input 2 connectors (RCA phono)
7.
Input 1 connector (3.5mm)
8.
Power indicator LED illuminates when power is applied.
9.
Clip indicator LED(left). If this LED is illuminated, reduce the input signal level.
10.
Clip indicator LED (right). If this LED is illuminated, reduce the input signal level.
11.
Signal present indicator LED illuminates when a signal is present at any input.
6.1
Sleep Mode
When no input signal is detected for a period of 5 minutes, the amplifier will enter sleep mode to reduce
power. The AV30MX-2’s Signal Sense Technology will power up the unit when a signal is subsequently
detected.
6.2
Level Controls
There are 2 level controls to adjust the level of the input signals. The level 1 control adjusts both the left
and right signal levels on input 1. Similarly, input level control 2 adjusts the left and right level of input 2
signals. Be certain to monitor the clip indicators when adjusting the input levels.
6.3
Remote Mute
The AV30MX-2 can be remotely muted (such as muting during a fire alarm). 5-12VDC should be applied to
the terminal block labeled “MUTE” on the rear of the AV30MX-2. Polarity should be observed when
connecting the triggering power source as the amplifier will not be muted if polarity is reversed.
