STEP-BY-STEP ASSEMBLY
2
#0964-3181
©2018 Stevens Industries, Inc.
Due to continuing product development, Stevens reserves the right to change specifications without notice.
3594.TM9418/9419.9/25/18
TM9418R – TM9419R
Lay
Table Top (1)
face down on floor. Note that
there are two pre-mounted
Table Leg Clips (4)
for
each leg. Each
Table Leg Clip (4)
has three pre-
installed
Clip Screws (5)
.
STEP
1
2-PERSON ASSEMBLY RECOMMENDED.
IMPORTANT!
Be sure to keep all parts supported during assembly to avoid damage.
Do not over-tighten screws or it will damage the pre-drilled holes;
snug fit is adequate.
Each adjustable table leg is made up of an
Upper
Leg (2)
and
Lower Leg (3)
.
Upper Leg (2)
has
a mounting bracket that will be attached to a pair
of
Table Leg Clips (4)
and the table top. The set
screw is used to secure
Lower Leg (3)
at the
desired height.
Lower Leg (3)
has a series of
pre-drilled holes for height adjustment, as well as
a leveler.
STEP
2
Slide mounting bracket on one
Upper Leg (2)
under lip of both
Table Leg Clips (4)
. The bracket
should slide all the way in to the second step. If
necessary, loosen the
Clip Screws (5)
to allow the
mounting bracket to slide completely into place.
When
Upper Leg (2)
is correctly positioned, the
two holes in the mounting bracket will align with
the pre-drilled holes in the table top, as shown.
STEP
3
side view
mounting
bracket
pre-drilled holes
for height adjustment
leveler
set screw
second
step
leg mounting bracket
slides under lip of
table leg clip and rests
against second step
