- Up to 8 TX2 Light can be synchronized with one RX2 Light receiver making it possible
for several people on a team to configure the same equipment.
- Larger number of CD/DVD Player models already available in its memory.
- Key lock function prevents accidental activation of the control keys.
- Sequence of commands “Volume (-)” available through the attenuation function (ATT-).
- Installing your SX2 Light:
You can install the receiver in a hidden place or somewhere visible so that you can
monitor its LED indicator (18).
It is important that the antenna (19) is not blocked by the car’s body or other metal parts
that will obstruct the reception of the radio waves. It may be installed parallel to the edge
of a window since glass does not block the reception or inside the glove compartment and
drawers.
The power cord (15) is polarized. The wire with a white stripe should be connected to
the positive terminal and the black wire to the negative one. The power source can be an
automotive battery, 9V battery or even a USB port.
The Infrared Transmitter (14) should be placed so that it points toward the control panel
of the equipment to be configured, make sure nothing is between the two.
16
14
15
18
19
17
Infrared transmitter (3m)
Power cable (50cm)
Synchronization key (SYNC/RESET)
Memory Key (MEM)
LED indicator
Antenna
14
15
17
16
18
19
• Important Features:
NOTE: Install as far away from amplifiers as possible
this avoids radio frequency interference.
The SX2 Light is already set up in the
Pioneer CD
Player standard, if you have a
different brand or model, follow these steps:
1.
Search for your device’s code in the Table of “Memory” Codes
(See Back)
.
2.
Press the MEM key (17) on the RX2 receiver. The LED indicator (18) will flash rapidly.
3.
On the TX2 Light transmitter press the first key on the table, the LED indicator (18) will
turn off for a moment and then flash again.
4.
On the TX2 Light transmitter press the second key on the table, the LED indicator (18)
will go out for a moment and then flash again.
5.
Lastly, press the third key on the table. The LED indicator (18) will go out. Your receiver
is now programmed for your chosen device.
The TX2 Light has a system that prevents the transmitter’s keys from being accidentally
pressed.
Follow these steps to lock and unlock the keys on your transmitter:
1.
Tap on the key POWER (02), the transmission indicator LED (01) will remain on.
2.
Press the Down Folder (
) (06) and Attenuation (ATT–) (10) keys at the same time.
The transmission indicator LED (01) will blink 2 times to indicate the keys are locked or 5
times to indicate the keys are unlocked.
The SX2 Light receiver and transmitters are paired before they leave the factory.
If the owner purchases new TX2 Light transmitters for his team or replaces an old one,
follow the steps below.
ATTENTION:
Before synchronizing your equipment, make sure there are no other
transmitters operating within range of the receiver since they may interfere.
– Follow the steps below to synchronize:
1.
Press the SYNC key (16) on the RX2 Light receiver. The LED indicator (18) will flash.
2.
Press any one of the TX2 Light transmitter’s keys except for the POWER key (02).
3.
The LED indicator (18) stops blinking. Synchronization is complete.
• Configuring the SX2 Light to control your CD/DVD Player:
• Lock or Unlock the keys:
• Synchronizing your Control:
1
2
LED
+12V (BLACK/WHITE)
GND (BLACK)
