• Deixe o ponto de aterramento do PROCESSADOR DE ÁUDIO o mais próximo
possível ao aterramento de outros equipamentos de áudio usados em conjunto.
• Não faça loop com terra. Prefira a ligação estrela, com todos os terras partindo de
um único ponto.
TROUBLESHOOTING
NO POWER/ LED POWER LIGHT DOESN’T BLINK:
• The power cables are not connected correctly (terBAT, GND and REM).
• The power cables are loose. Check the connections.
• REM has no signal. Check to see if the REM connection is receiving approximately
+12V of current.
• Loose ground connection.
• The external fuse is blown. Verify that a 1.0A fuse is installed.
ICON CONSTANTLY SHOWS LOADING:
• The connection was lost. Reconnect by searching for new devices (icon in the upper
right-hand corner).
BLUETOOTH IS NOT VISIBLE/ UNABLE TO PAIR:
• Close the app, restart (turn off and then on) the smartphone or tablet’s Bluetooth and
then open the app again.
• Turn the amplifiers off and then restart the AUDIO PROCESSOR.
NO SOUND:
• The input and output gain control is at the lowest setting. Increase the setting.
• Output is off or muted. Turn it on.
• Audio input is without a signal. Check the audio source and RCA cables.
UNWANTED NOISE:
• All feeds and RCA cables should be checked beforehand and any irregularities cared
for properly. (We recommend Triple Shielded RCA Cables – STETSOM).
• Utilize suppressing/insulated cables on the spark plugs.
• Run the input and output RCA cables away from any other cables, as they are
particularly prone to interference.
• Install a separate power source (+12V) for the sound system. Use a 1A fuse 30
centimeters from the battery as the best precaution.
• Ground the AUDIO PROCESSOR properly. Remove paint from the chassis at the
selected point, and connect the wire using a grounded terminal. In order to prevent rust,
insulate it with paint.
• Place the ground wire for the AUDIO PROCESSOR as close as possible to the
grounds for the other sound equipment it is used with.
- Do not loop the ground. Avoid using multiple grounds. If possible, use a star
connection where all the grounds run from a single point.
ESPECIFICAÇÕES TÉCNICAS
Número de Canais de Entrada / Number of Input Channels:
2
Número de Canais de Saída / Number of Output Channels:
4
Equalizador Gráfico / Graphic Equalizer:
15 Bands, Gain +/- 12dB
Presets de Equalização Gráfica / Graphic Equalizer Presets:
12
Equalizador Paramétrico / Parametric Equalizer:
5 Bands (1 Input + 4 Output)
Gain +/- 12dB, Q Factor 0.4 – 10.0
Resposta em Frequência / Frequency Response:
10Hz – 22.5kHz @-1dB
Crossover Variável / Variable Crossover:
Butterworth 12/18/24/36/48 dB/Octave
Linkwitz-Riley 12/18/24/36/48 dB/Octave
Roteamento entre E/S / Routing between I/O:
A,B or A+B
Delay / Delay:
0 – 8ms (275cm)
Phase / Phase:
0° or 180°
Limiter / Limiter:
Threshhold -24 to 0dB
Attack 0.1 to 100.0ms
Release 1 to 1600ms
(Attack and Release manual or automatic)
Ganho de Saída / Output Gain:
- 45 to +15dB
Master Level / Master Level:
0 – 100%
