NO POWER / GREEN LED NO LIGHTS:
- Power cables are not properly connected (terBATT, GND and REM).
- Power cables with bad contact. Check connections.
- REM without signal. Check if REM connection is receiving power near +12V.
- Bad contact ground connection.
- The internal fuse is burned. Attention to the correct value of the fuse (0,5A).
NO SOUND:
- Gain controls at minimum level. Increase the level.
- Power switch the channel off. Turn it on.
UNWANTED NOISE:
- All RCA and power cables must first be checked, to rectify any irregularities of them.
- Use suppressive cables at ignition candles.
- Route RCA cables input and output away from any other cable, because they are more sensitive to
interference.
- Make the connection of power (+12V) separate of the sound system. Use one fuse of 1A away 30 cm
from the battery to protection.
- Make a good grounding of CROSSOVER. Remove the paint from the chassis of the vehicle at the
desired point. Screw the wire using a ground terminal. To protect from oxidation, insulate with paint.
- Let`s CROSSOVER grounding point as close as possible to other audio equipment used together.
- Do not loop with the ground wire. Avoid using several ground wires. Prefer the star connection, with all
wires from a single point.
5 WAYS
STX 104
High Pass:
400Hz to 10KHz (12 dB/8ª)
Mid High Pass:
150Hz to 12,5KHz (12 dB/8ª)
Mid Low Pass:
70Hz to 10KHz (12 dB/8ª)
Low Pass:
50Hz to 250Hz (12 dB/8ª)
Subsonic Filter:
20 / 30 / 50 / 80Hz (24 dB/8ª)
Bass Boost:
(25Hz to 110Hz) (0 to +12dB; 60Hz)
Max Output Voltage:
9V RMS
Max Input Voltage:
4V RMS
Signal to Noise:
>90dB
Input Impedance:
10K OHMS
Total Harmonic Distortion:
< 0,02% THD
Channel Separation:
> 80dB
Frequency Response:
20Hz to 200 KHz
Work Voltage:
10V to 16V DC
Consumption:
250mA
Output Impedance:
50 OHMS
Dimension:
33 x 264 x 160 mm
Weight:
780g
HOW TO PROCEED IN CASE OF PROBLEMS
HOW TO PROCEED IN CASE OF PROBLEMS
TECHNICAL SPECIFICATIONS
TECHNICAL SPECIFICATIONS
Phone
: (786) 2651960 - www.stetsom.com - [email protected]
USER’S GUIDE
