3
1. RCA JACK INPUT:
Input of the signal to be amplified. Connect to the radio/
player using high quality shielded RCA cables to prevent unwanted noise.
2. LEVEL:
Level control for the signal at the amplifier’s input.
3. CROSSOVER:
▪
HIGH PASS FILTER (H.P.F.):
This variable control allows you to select the
initial frequency from
10Hz ~ 90Hz
that will be reproduced by the amplifier.
▪
LOW PASS FILTER (L.P.F.):
This variable control allows you to select the
final frequency from
90Hz ~ 22KHz
that will be reproduced by the amplifier.
4. BASS BOOST:
▪
BASS:
Variable control for bass boost from
0dB ~ +10dB
.
▪
FREQ:
Variable control for
BASS
boost frequency from
30Hz ~ 70Hz
.
5. FLAT KEY:
This switch allows you to turn the
FLAT
mode on or off. Settings
made on the
CROSSOVER and BOOST
controls will be turned off when
using this mode.
6. OUTPUT CONNECTOR (SPEAKERS):
MONO output of amplified signal for
speakers connection. Check the minimum impedance and polarities before
performing the installation.
Input, output and audio controls
4
3
2
5
6
1
ventilation
ventilation