2.
First time use
4.
Installation Tips
5
.
Troubleshooting
3.
Fixture Assembly
If the solar panel is covered by a protective film, remove it before using the product.
Change the switch to the ON position.
Place the solar light in a location where it can receive a full 8 hours of sunlight to allow the rechargeable battery/batteries to reach maximum
capacity.
•
If the soil is of a loose, sandy or organic type
, grasp the post with both hands near the spike and firmly push into the ground.
•
If the soil is hard
, pour some water onto the ground to soften it.
•
If the soil is stony
, soften the ground with a rake or shovel and remove large rocks. Dig a small hole, insert the fixture spike, replace the soil and
tap down.
• Never push fixture into the ground by the fixture head.
If the light does not turn on at dusk after 8 hours of charging :
• Ensure that the solar light is in a bright sunny location and not in a shady area during the day.
• Make sure that the light’s photocell is not affected by other light sources at night.
• Make sure that the switch is ON.
• Verify that the battery/batteries are making contact with the terminal and that they have been inserted in the correct polarity.
• Attach the top cap onto each lens by pressing
it downward on the lens. Attach the lens to the
post by pressing them together.
• Attach the plastic spike to the post by
pressing them together.
Top Cap
Lens
Post
Poteau
Plastic spike
ATTENTION
SPIKE
IS INSERTED
IN POST
ATTENTION
LE PIQUET
EST INSÉRÉ
DANS LE POTEAU
