Sternberg Lighting LUNARIA LU300 Installation Instructions Download Page 4

Page: 4 / 4

[LU300

– LUNARIA Bollard], Installation Instructions, Revision A

Page 4 of 4

Step 8:

Return the top of bollard

onto the base

– slide



DOWN then

TWIST in 10



and



DOWN as

shown.
NOTE: Confirm assembly is level.

Step 9:

Secure with three saved set

screws and fully tighten.

FINAL VIEW

Revision History

Rev Description of Revision

Release Date Manufacturing

Engineer

Design Engineer

Initial Release

10/14/2019

Grant Burton

N.KOZYREVA

Summary of Contents for LUNARIA LU300

Page 2: ...IST in 10 and UP as shown and put to the side NOTE Do not disconnect wires with driver assembly Step 4 Remove the LED driver bracket assembly and save the two sets of screws and washers Step 5 After the anchor assembly has been installed refer to anchor bolt templates mount the base NOTE Make sure base is level on all sides ...

Page 3: ...uctions Revision A Page 3 of 4 or Step 6 Install the LED driver bracket assembly back in to the base with existing two sets of screws and washers Wiring Diagram Step 7 Connect supply wires to the driver assembly according to the wiring diagram ...

Page 4: ...to the base slide DOWN then TWIST in 10 and DOWN as shown NOTE Confirm assembly is level Step 9 Secure with three saved set screws and fully tighten FINAL VIEW Revision History Rev Description of Revision Release Date Manufacturing Engineer Design Engineer A Initial Release 10 14 2019 Grant Burton N KOZYREVA ...