12
13
Carefully push the sensor into the
faucet’s body to gain access to the
battery and pull it out of the body together
with the battery.
Replace the used battery with a new 9V
battery. A lithium battery is recommended.
Release the Allen screw to carefully
remove the faucet’s body.
Disconnect the connector from the elec-
tronic unit’s connector.
If your model is Swan 1000
:
Release the handle-set-screw to
remove the mixing handle. Release the
Allen screw to carefully remove the axis
assembly by pulling it out.
Turn off the shut off valve (angle valve).
If your model is Swan 1010
, go to
1
2
When the battery weakens, the red indicator light will blink at a constant rate. The battery
must be replaced within two weeks.
BATTERy REPlAcEmENT
BATTERy REPlAcEmENT
To replace the battery at Swan 1010 \ Swan 1000 models:
3
4
Prior to reassembling the electronic unit and the battery, make sure that the o-ring is still
in its groove and not damaged. Replace it with a new one if needed. Clean and lubricate
it with silicone grease.
Important:
Make sure that the faucet is not wet when reassembling the electronic unit.
5
3
screw
connectors
Reconnect the electronic unit’s
connector to the solenoid connector.
Place the body, and tighten the screw.
If your model is Swan 1000:
Reassemble the axis-assembly and tighten
the Allen screw. Reassemble the mixing
handle and tighten the Allen screw.
Turn on the shut off valve (angle valve).
Carefully place the battery inside the
body and reassemble the electronic
unit in its place. be sure to insert the elec-
tronic unit all the way back into the opening
in the faucet’s body by pushing it moder-
ately into the o-ring.
Swing the sensor gently to align it with its
location. be careful and make sure that you
do not tear the o-ring. If torn replace it with
a new one.
6
7
o-ring
electronic unit
screw