5
FaucET INsTallaTIoN
Step 1 – Remove all mounting hardware
shut off water supply and remove the hexagonal
nut, the disk and the gasket. do not remove the
o-ring from the base of the faucet.
Step 2 – Installing the faucet
1. Place the faucet with o-ring into the hole in
deck or lavatory. Make sure the o-ring is located
between the deck or lavatory and the bottom of
the faucet.
2. slide the gasket over the flexible hose.
3. secure the faucet to the deck or lavatory with the hexagonal nut and the disk.
Step 3 – Connecting the water supply
1. a. For Green time, Green time B, Green time e: connect the flexible pipe to the
water supply.
b. For Green time 1000, Green time 1000 B, Green time 1000 e: connect the red
flexible pipe to the hot water supply and the blue pipe to the cold water supply.
2. Make sure that the filter/s is/are installed between the flexible pipe and the shut
off valve (not supplied).
Step 4 - Connecting the power source
1. connect the power source:
a. For Green time B or Green time 1000 B: install the battery box at the wall
underneath the sink using the two sided adhesive foam facet. the cable
connection must point down. (You can use an optional extension cable in order to
assemble the battery box up to 10ft. away from the sink.)
b. For Green time e or Green time 1000 e: Plug the transformer into the electricity
socket and connect the connectors.
Important:
In order to avoid entering into the adjusting mode, wait 10 seconds before
you will operate the system.
2. turn on the central water supply and the shut-off valve/s.
3. check for leaks.
O-Ring
Gasket
Disk
Hexagonal
nut
Note:
this faucet includes a special aerator that allows you to adjust
the water stream direction on site in order to prevent water splashing
if needed. to change the angle of the water stream, simply move the
adjustable tilting plate by pressing it smoothly.
