Steris HarmonyAIR G Series, Operator'S Manual

Page: 36 / 60

3-12
10043124
Operator Manual Operating Instructions
3.7 Video Camera
Installation or Removal
• Installation
Important: If the lighting system is camera-ready, the bottom-most
lighthead on the central spindle (lighthead 1) is the only lighthead in
the system capable of accepting a camera module. Unless the
system has been preconfigured for video (i.e., is camera-ready), it is
not possible to install a camera module.
1. Rotate lighthead until lens faces the room ceiling.
2. Remove standard lighthandle and lighthead adaptor by
unthreading it from the support mounting ring.
3. The camera is secured to the lighthead by threading it into the
same support used by the standard handle.
a. Align the post with recess, this should align system
connector properly, and install camera assembly to
lighthead. Refer to
Figure 3-9 .
b. Turn ON camera at the wall control.
c. Verify all functions of the camera operate correctly using the
wall control.
4. Once camera functions are verified, press the OFF touch pad on
the face of the wall control.
• Removal
1. Rotate lighthead until perpendicular to floor.
2. Unthread camera housing from mounting ring and remove.
3. Install standard handle.
CAUTION – POSSIBLE
EQUIPMENT DAMAGE: When
installing or removing the
video camera be careful to
place it in a secure location to
prevent it from rolling,
dropping and breaking. Also,
to avoid scratching the lens
surface, do not stand camera
up with lens side facing down.
!
Figure 3-9. Optional Camera Installation