Steris HarmonyAIR G Series, Operator'S Manual

Page: 28 / 60

3-4
10043124
Operator Manual Operating Instructions
NOTE: Press the decrease intensity button (-) on the lighthead
surgeon's control for an additional two seconds, to turn OFF all
lightheads in the system.
3.2 G5 Lighthead
Module Status
Indications
LEDs on the wall control indicate HarmonyAIR Surgical Lighting
System G Series module status. If the wall control module status LED
is lit, it indicates the module(s) has failed. A failed module(s) should
always be changed at the earliest opportunity.
Another module status LED is located on each lighthead (see
Figure 3-3 ). When flashing, the lighthead LED indicates the
module(s) should be replaced.
• Check the module status LED each time the surgical light is
used.
• If the module status LED is blinking, call your STERIS service
representative. After the module is replaced, LED indicators on
lighthead and wall control stop blinking.
Figure 3-3. G5 Lighthead Module Status Indicator
LED Indicator