Steris Harmony LED Wall Control Unit, Operator'S Manual

Page: 35 / 74

5-7
Operating Instructions Operator Manual 10083002
5.5 Lighthead
Positioning
Lightheads can be positioned by using either the sterile handle, or
by grasping the non-sterile handle around the lighthead housing.
Each lighthead can be positioned as listed from outside or from
within the sterile field. To optimize shadow control, position the
lighthead as appropriate before starting the intended surgical
procedure.
HarmonyAIR Surgical Lighting System (M5 and M7)
Lighthead/Spring Arm Assemblies may:
See Figure 5-6 .
(1) rotate continuously around central hub;
(2) rotate continuously at horizontal suspension arm/spring arm
connection;
(3) rotate continuously at spring arm/yoke connection;
(4) tilt forward or backward in yoke approximately 310°; and
(5) move up or down by pivoting at suspension elbow 15° up and
85° down (total range: 100°).
CAUTION – POSSIBLE
EQUIPMENT DAMAGE
HAZARD: Do not bump
lightheads into walls or other
equipment. Always use
handles when positioning
lighthead during surgical
procedures, or when
cleaning or servicing the
lighting system.
!
Figure 5-6. M5 and M7 Lighthead Positioning
85°
15°
310°
Unlimited
Unlimited
Unlimited
2
3
4
5
1
5