Steris Cmax, Operator'S Manual

Page: 107 / 218

6-2
764333-268
Figure 6-1. Table Sensor Calibration
8. Display shows ADJUST MODE.
NOTE: During table sensor calibration, note the
following:
1) The REV. ORIENT LED must be OFF.
2) Do not press LEVEL button during procedure
or control exits Calibration Mode without
storing the values.
3) Pressing
FLOOR LOCK
button during
procedure orders the control to skip displayed
articulation. This is NOT recommended during
a final calibration.
9. If ADJUST MODE does not display or REV.
ORIENT LED is ON, turn Hand Control OFF then
ON and repeat Step 7 until correct results appear.
10. Press REV. ORIENT button, display shows
LEVEL ADJ .
11. Using a level, position tabletop (starting with seat
section) so all sections are level in both horizontal
directions.
12. Slide tabletop until it is approximately 3/16" past
foot end of tilt frame (see Figure 6-1). This is
known as “Zero Slide” position.
13. Press REV. ORIENT button to save setting.
14. With display showing TILT L MAX , tilt tabletop
to maximum left tilt position and press REV.
ORIENT to save setting.
15. With display showing
TILT R MAX
, tilt tabletop
to maximum right tilt position and press
REV.
ORIENT
to save setting.
16. Display shows TREND MAX . Use Tilt Left button
to return table to center. Do not use LEVEL button.
17. Put table into maximum Trendelenburg then
press REV. ORIENT button to save setting.
18. Display shows R TREND MAX . Put table into
maximum Reverse Trendelenburg then press
REV. ORIENT button to save setting.
19. Display shows LEG D MAX . Use TREND button
to return table to center. Do not use LEVEL button.
20. Lower leg section to maximum position and press
REV. ORIENT button to save setting.
21. Display shows
LEG U MAX
. Raise leg section to
maximum position and press
REV. ORIENT
button to save setting.
Tilt frame
Extend table
top 3/16”
beyond the
foot end of the
tilt frame.
Tabletop
Tabletop
Extend Tabletop
3/16" (4.8 mm)
Beyond Foot
End of Tilt
Frame
Tilt Frame