3-6
122998-741
Operator Manual
Component Identification
3.6 Typical Printouts
Figures 3-3 and 3-4 are examples of typical cycle printouts.
•
POWER UP
When Power Switch is set to
POWER
, generated printout lists
time and date, control was turned on, and unit's serial number.
•
CYCLE START
When
CYCLE/START
touch pad is pressed twice to begin
selected cycle, generated printout lists name of cycle started,
time and date cycle was started, cycle number, and unit
number.
•
IN-CYCLE PERFORMANCE
During a cycle, generated printout lists start and end time of
each phase, along with actual temperature of solution/water in
chamber sump.
•
END-OF-CYCLE PERFORMANCE SUMMARY
At end of a cycle, generated printout lists time cycle was
completed, maximum wash and rinse temperatures reached
during cycle, and total cycle processing time.
•
ALARM CONDITION
When an alarm condition occurs, generated printout lists type of
alarm and time it occurred (see Figure 3-4). Once operator
presses
ALARM REPLY
touch pad, generated printout lists time
when alarm was acknowledged.
Figure 3-3. Sample Printout
Power
Up
Cycle
Start
In-Cycle
Performance
End-of-Cycle
Performance
Summary
Figure 3-4. Sample Alarm
Printout
