INSTRUCTIONS
HOLD BUTTON
If you need to maintain a value in the screen, press the button
marked with an H, then the current value will be displayed in the
screen, until you press the button H, once again.
LIGHT BUTTON
Press this button if you want to turn the backlight on, specially
when you do measures at nite. Press the button with the icon of
a sun and the backlight will turn on for 5 seconds (this light con-
sume many energy, just use it in special conditions).
If the battery voltage is under 7 volts, in the screen will display a
battery icon, but if you use the backlight at the same time, after
it turn off, the battery icon may disappear, because the voltage
down.
MEASUREMENT METHODS
MEASURING DC / AC VOLTAGE
1.- Connect the red testing point to the jack signaled “V
Ω
” and
the black testing point to the jack signaled “COM”.
2.- Set the dial to the VDC / VAC setting
3.- Connect the testing points to the equipment to be measured.
4.- Turn the equipment to be measured on, the voltage will ap-
pear on the LCD screen. The polarity will also appear.
MEASURING DC / AC AMPS
1.- Connect the red testing point to the jack signaled “mA” when
measuring up to 200 mA, and to the jack signaled “A” when
measuring above, and the black testing point to the jack signaled
“COM”.
2.- Set the dial to the VDC or VAC setting .
3.- Open the circuit to be measured and connect the testing
points (serial) where the current must be measured.
4.- Read the current value in the screen.
For resistance over 1Mohm, the meter can be delayed for
few seconds, this is normal because of the high value of the
resistance.
ENGLISH
ENGLISH-8
For resistance over 1Mohm, the meter can be delayed for
few seconds, this is normal because of the high value of the
resistance.
