b) Set the dial to the right position. Connect the testing points to
the circuit to be measured. Must be between 200mV and 10V
rms of AC, if is higher than those, the accurate of the reading
may be less.
6.7. TRANSISTOR MEASUREMENT
a) Set the dial to the hFE range.
b) Determine if the transistor is NPN or PNP and localize the
emitter, base, and collector. Connect the testing points in the
jacks for transistor testing.
c) The multimeter will show the grade of transistor ampli
fi
cation
with base current condition of lb-10
μ
A and VCE 3,2 V
7.- MAINTAINING
7.1 Replacing the battery
When the energy of the battery is low, a small battery icon
displays in the screen. To replace the battery, you must remove
the screws from the back cover.
7.2 Replacing the fuse
Use fuses with next speci
fi
cations: (0,3A/250V and 10A/ 250V)
WARNING
TO PREVENT ELECTRICAL SHOCK
Before removing the cover from your multimeter, make sure the
testing points are disconnected to avoid the risk of electrical
shock.
Do not operate the meter if it’s not placed in a solid and stable
surface.
The characteristics for this multimeter are subject to change
without notice.
The characteristics for this multimeter are subject to change
without notice.
ENGLISH
ENGLISH-8