2.- Determine if the transistor is NPN or PNP and localize the
emitter, base, and collector.
3.- The multimeter will show the approximate hFE value with
base current condition of 10 uA and VCE 2.8 V.
MEASURING AUDIBLE CONTINUITY
1.- Connect the red testing point in the jack signaled “V
Ω
Hz”
and the black testing point in the jack signaled “COM”.
2.- Set the dial to the “)))” range.
3.- Connect the testing points on the circuit to be measured. If
the resistance is less than 100Ohm the multimeter will sound.
REPLACING BATTERY AND FUSE
The fuse rarely needs to be replaced and when it does, it is
usually due to an error in operation.
If “BAT” appears on your LCD screen, the battery needs to be
replaced.
To replace the battery and the fuse (200mA / 250 V), remove the
cover from the multimeter removing the three screws on the back
of the multimeter. Replace the fuse and/or battery and replace
the cover on your multimeter.
Precaution
Before removing the cover from your multimeter, make sure the
testing points are disconnected to avoid the risk of electrical
shock.
ACCESSORIES
User’s manual
Testing points
Battery
The characteristics for this multimeter are subject to change
without notice.
•
•
•
ENGLISH
ENGLISH-5
The characteristics for this multimeter are subject to change
without notice.
