Mini LED lamp
with motion sensor
LAM-705
INSTRUCTION MANUAL
V0.1 0718A
1
2
3
4
5
IMPORTANT
CONTENT
INSTALLATION
FUNCTIONING
PLACE BATTERY
CAUTIONS
• Do not expose the product to high temperatures.
• Use a soft, dry cloth to clean the equipment.
• This device is not intended for use by people (including children), whose physical,
sensory or mental abilities are different or reduced, or who lack experience or
knowledge.
• Children should be supervised to ensure they do not use the device as a toy.
Select the place to install the lamp; it must be a place
where it can properly receive sunlight, and at a height
between 2 and 4 meters above the ground.
Glue the template in the selected place and make 2 holes
in the indicated marks.
Insert the dowels into the holes.
Position the screws so that they protrude
from the wall to allow the lamp to hang.
Install the lamp and firmly tighten the
upper screw.
During the night, the warm-light LEDs will remain on to indicate the
location of the lamp.
Automatic ON / OFF
The lamp will turn on automatically as soon as
detect movement.
Turning the system on and off
Press to activate or deactivate the system
1. Remove the screws and the compartment cover.
2. Insert the lithium battery. Be sure to place it with the correct
polarity.
3. Replace the cover and screw.
Sensor lamp
battery compartment
Dowels (x2)
Screws (x2)
Adhesive label
SPECIFICATIONS
The specifications may change without prior notice.
Detection: 3 to 4 metres
Detection angle: 120 °
Battery: 3.7 V - - - 1 200 mAh
Lumens: 170 lumens
IP protection: IP 44 (moderated dust and rain)
Working time: Up to 10 hours
Interval of time: 30 +/-5 seconds
Solar panel: 0.8 W (monocrystal)
Read this instruction carefully to avoid any malfunction.
The information shown in this manual serves only as a reference for the product.
Due to updates there may be differences.
Please check our website (www.steren.com) for the most recent version of this manual.
+
+
+
+
For the battery to be fully charged, wait for 3 to 5 days.