INSTALLATION
Your new Signal TV booster includes two pieces, one of them is
the pre-ampli
fi
er, which is connected to the mast and the other is
the ampli
fi
er, which is connected into the house.
1.- Place the pre-ampli
fi
er in the mast of the antenna, between
90cm a 1 metre under the antenna.
2.- Use the brackets to fasten it up.
3.- Connect the ends of the cable to the ampli
fi
er’s input connec-
tors. You can do this connection using any one of the included
cables (can be the
fl
at cable or coaxial cable) (See Fig 1 and 2).
Flat cable
Separate the cable and cut it (See Fig. 2), approximately 15 cm
in both extremes, then remove the isolation around 2,5cm for
each tip.
Connect one extreme to the ends of the antenna and the other
extreme to the pre-ampli
fi
er’s input connector. The input con-
nectors can be reached removing the waterproof protector. Even
you can reach the connectors without removing the screws com-
pletely. When you connect the cable make sure to place it under
the holder (Fig. 3).
Fig. 1
Fig. 2
ENGLISH
ENGLISH-8
