USER MANUAL
Motion sensor with
wireless bell
INSTALLATION OF THE BELL
Sensor
If you connect it with a AC
adapter, consider the length of
the cable.
Carefully remove the base as
shown below.
Remove the cover. Insert 3 “AAA” batteries.
Ensure that the polarity is
correct.
1
2
3
IMPORTANT
CAUTIONS
INSTALLATION OF THE SENSOR
BATTERY PLACEMENT
HOW TO USE
Before to use the product, please read carefully this manual to avoid any
malfunction. The info in this manual is shown as reference.
Due to updates can exist differences. Consult our website www.steren.com to
obtain the current version of this manual.
• Always use a soft and dry cloth to clean it.
• Don’t use or store the device in places where exist water or splashes.
• Don’t place heavy objects over the
• Avoid dropping the device, it could cause severe damage.
• This product is NOT a toy; keep it away from children.
Set the sensor into the base
again.
Use the support to make drill
marks into the surface where
you want to install the
device.
Drill. Then insert anchors and screw
the base into the surface.
1
2
3
SPECIFICATIONS
Remove the cover.
Bell
Insert 2 “AAA” batteries. Ensure that the
polarity is correct.
Make drill mark into the surface where you want to install the device.
Slide the switch toward position. Each that the sensor detects movement,
the alarm will be hear approx 5 seconds.
Slide the switch toward position. Each that the
sensor detects movement, the alarm will be hear with
the selected tone.
Place the bell over the screw.
In the bell choose the melody and
the volume level of the alarm tone.
Local alarm
Remote alarrm
1
Sensor input: 4.5 V - - - (3 x AAA)
9 V - - - 250 mA
(with power converter)
Bell input: 3 V - - - (2 x AAA)
Transmission frequency: 314.93 MHz
Consumption: 0.2 W/h
Stand-by power consumption: 0.05 W/h
Specifications may change without notice
1
1
2
2
2
3
Drill. Then insert an anchor and screw, ensure that the screws sticks out
from the wall some milimetres.
Volume
Melody