4
Single Sender with multiple receivers or Wireless Amplifiers
Sync your SENDER and first RECEIVER exactly as shown above. Then again press the M button on the SENDER until the power
indicator begins to blink green/blue, then release. While the SENDER is blinking, press and hold the M button on the second
receiver until the power indicator begins to blink green/blue, then release. The power buttons on both devices will continue
to blink, then turn steady blue. At this time, the second RECEIVER is also in sync and ready for use.
Note:
If you are syncing the second RECEIVER, while the SENDER and first RECEIVER are in use, they will temporarily loose
sync while the SENDER is syncing with the second unit. Continue as above with each additional RECEIVER to be used with the
SENDER. Note that you may use combinations of RECEIVERS and WIRELESS AMPLIFIERS.
Multiple Independent Sender/Receiver Sets
This may be necessary in environments where multiple sources need to be sent to multiple destinations in the same general
area, or to multiple inputs on a single sound system. Note that each SENDER must send to a unique receiver or group of
receivers. Multiple SENDERS cannot be synced to a single RECEIVER.
Sync your SENDER and first RECEIVER exactly as shown in the sections above. If multiple receivers are used with a single SENDER,
use the same process as above as well.
Take a second SENDER, and press the M button, just as above. Using the same method as shown above, sync a RECEIVER to
that SENDER. As long as your first set is already in sync prior to beginning the sync process of the second set, the second set will
choose a different frequency, and remain isolated from the first.
Additional Setup and Operation Note
If the final location of the SENDER and RECEIVER are not close together, it may be more convenient to temporarily locate the
units in the same area to sync. Once they have been synced to each other, the internal settings will remain intact, even with
power removed. It is perfectly acceptable to sync these in a convenient location, then move them to their permanent spot.
Important Antenna Note
As mentioned earlier, the screw connections on the included antennas are quite delicate. They only need to be finger-tight on
the threaded connectors. If repositioning the antenna is necessary after installation, be sure to loosen the connector prior to
rotating the antenna.
