![Stellar Hearth Products 34S-20GL Installation And Operating Manual Download Page 23](http://html1.mh-extra.com/html/stellar-hearth-products/34s-20gl/34s-20gl_installation-and-operating-manual_1371590023.webp)
Page 23
16400-7806 G4S REV G
C. REMOVE GLASS FRAME ASSEMBLY
B. INSTALL GLASS FRAME ASSEMBLY
1.
Apply the suction cups to the outer glass panel following the instructions included with the suction cups.
2.
Gently lift the glass until the bottom edge is clear of the groove it sits in.
3.
Bring the bottom edge of the glass towards you while lowering it to disengage it from the top groove.
4.
Sit the glass on a padded surface to protect it. IMPORTANT: Protect the glass's edges.
5.
Remove the lower trim piece that sits between the layer of glass.
6. Remove the inner trim vertical pieces.
7. Using the suction cups, remove the inner glass in the same manner.
Refer to Section 6 (Glass Frame Assembly Identification Figures 6A & 6B.1) when installing and removing the glass frame assembly.
6 - GLASS FRAME ASSEMBLY
IMPORTANT: PLASTIC GLASS EDGE PROTECTORS
The fireplace is shipped with a plastic edge protector on
the outer pane of glass only.
See Figure 6B.2
Inner Glass
1.
Unwrap the panes of glass carefully making sure to protect the
edges.
2.
Apply the suction cups to the inner glass assembly, following
instructions included with the suction cups.
3.
Lift the glass into place. The top edge slips into the top groove;
lift into the groove until the bottom is clear of the bottom trim.
Slide the glass down into the inner bottom grove. See Figure 6A
4. Push vertical glass trim into place on each side. See Figure 6B.3
5. Place the long horizontal trim piece between the lower glass clips.
Slide back against the vertical trim piece. See Figure 6B.3 and
Figure 6B.4.
Outer Glass
6.
Apply the suction cups to the outer unframed glass and lift it into
place in the same manner as the inner glass.
Figure 6B.3 - Vertical Trim Piece
Figure 6B.4 - Horizontal Trim Piece
Figure 6B.2 - Outer Glass Edge Protector
Top/Bottom Glass Pane
U-Shaped
Edge
Protector
WARNING: RISK OF INJURY!
DO NOT remove glass until unit is cooled to room
temperature. Glass breakage could occur.
Summary of Contents for 34S-20GL
Page 2: ...INS_CUST UL REV E Page 2...
Page 54: ...INS_CUST UL REV E Page 54...
Page 55: ...Page 55 16400 7806 G4S REV G...