W W W . S T E L L A D O R A D U S . C O M
W W W . S T E L L A D O R A D U S . C O M
i
REPEATER
i
REPEATER
2
2
2- Outdoor antenna placement.
1-Survey
Step-by-step installation instructions
3- Loose installation
4- Call and data tests
5- StellaControl - Remote monitoring
On the roof, point the outdoor antenna towards the nearest cell tower. This nearest, most
suitable cell tower can be either seen by eye or located using on-line tower maps.
When the best direction is found, loosely fasten the antenna to a pole.
The Yagi should be clear of all nearby obstructions, like metal railings or other roof
structure.
Before starting the installation, conduct call and data speed tests outside the building to understand the available
signal in your area. For the required mobile operators note:
•
Call quality. (do you experience dropped voice calls?)
•
Data speeds up and down.
•
Signal strength (signal bars or dBm)
•
Band (only available on android phones)
•
Service: H+/4G/5G
Whatever signal is available outside your property, a repeater will distribute inside the property.
For android phones, the app,
Network Cell Info Lite
is recommended.
Loosely drop the 15m SD400 cable from the outdoor antenna to a location inside the building where call tests can be conducted.
Attach this cable to the repeater and power on the repeater. On the LCD, pay attention to the signal bars for each frequency. 4,5 or
6 signal bars signifies a good signal at that frequency.
Next, attach one of the inside antennas to the repeater and point it into the room.
Do call and data tests for each mobile operator. The tests should be comparable to those tests conducted outside the property.
Once satisfied with the results, fasten the outdoor antenna and install the cables permanently.
Connect the iRepeater to a live ethernet conection. Log onto your stellacontrol account.
Manage, monitor and control all your iRepeaters from the cloud.
To learn more snap the QR code.
Add lineamps for more coverage.
For larger buildings, lineamps and splitters can be installed after the repeater. This allows extending the signal a
further 100m into the building. See cable length rules below.
Cable Assembly
Self assembly of cables. Pay careful attention to the N-connectors.
The silver braid must be long.
Braiding must not touch
centre pin. Check Carefully.
Braid must overlap with the
collar of the connector. This
is what holds the connector
in place.
Centre pin must be level with the
steel collar. Not pushed inside.