4 – EN
Figure 2
Plastic washer D5
Flat head screw M4
x 8 mm
Rear of the speak
er
4. Check the hole in the center of the mounting post and make sure that the 8 # - 32 5/8 “screw, the ST4.2 x 19
self-tapping screw, the ¼“ - 20 x ½ “screw, or the M5 x 20 mm screw fit iin it (see Figure 3).
Figure 3
Screw ¼“ – 20x7/8“
Plastic washer D5
Screw M5 x 20 mm
Self-tapping screw ST4.2 x 19
Screw 8# 32 x 5/8“
Plastic washer D5
Plastic washer M5 x 1/8“
Rear of the speak
er
Plastic washer M5 x 1/8“
5. Once you select the correct screw size, insert the screw through the mounting post and attach it to the
rear speaker cover.
Note:
If the screw cannot be tightened up, use the plastic washer M5 x 1/8“ to toghten the screw.
Note:
After the installation is complete, insert the plastic washer D5 into the post. (The D5 plastic washer is not
required if you use an M6 x 20 mm screw to mount the speaker.)
Mounting in the keyhole hole
1. If your speaker is equipped with a keyhole hole, you need to use 8 # - 32 x 5/8 ”screws in combination with
the keyhole nut to attach it.
2. Assemble the mounting post with 8 # - 32 x 5/8 “screws and keyhole nuts, but do not tighten the screws
or the nut (see Figure 4).
Note:
Make sure the nut is installed with the threaded side toward the post.
