33
6
OPERATING INSTRUCTIONS
6.1
Multiwinch/underwater camera
The camera system is primarily controlled via the NeoVision or Vision software on a computer or a
control desk located on the barge or land base.
It is also possible to operate the winch from the cage edge, this makes accessing the camera for
maintenance/inspection purposes easier.
The winch has three buttons, these are marked with “up”,
“down” and “sideways”:
1.
Press “Up” to:
Move the camera up
2.
Press “Down” to:
Move the camera down
3.
Press “Sideways” to:
Move the camera from the winch
4.
Press “Sideways” to:
Move the camera towards the winch
Alternately, an older winch may only have two buttons, one to move the winch up/down, one to move it
sideways, and both buttons must be used to move the camera to/from the winch.
Consult the NeoVision/Vision user manual for a complete description of navigation and
configurations.
6.2
Surveillance camera
The surveillance camera is controlled via the NeoVision or Vision software on the PC. It can be
controlled via the gamepad, arrows on the PC’s keyboard or by clicking on the different arrows in the
camera software.
Some of the functions on the gamepad are shown in the figures below.
Consult the NeoVision/Vision user manual for a complete description of navigation and
configurations.
Summary of Contents for Orbit-200
Page 34: ...34 Figure 22 Gamepad Figure 23 Gamepad backside ...
Page 46: ...46 ...
