Version 12.2022
Assembly instructions
35
9
Tool change
1. Remove the tool
4
as described in
.
2. Completely unscrew the clamping nut
3
from the spindle
1
.
3. Replace the collet
2
.
4. During assembly, ensure that the groove (yellow) of the collet
5
engages with the eccentric forming
(yellow) of the clamping nut
6
. Only this will ensure the proper functioning of the collet.
5. While inserting the tool
4
into the collet
2
, ensure that the square end of the tool locks into that
(yellow) of the collet by gently twisting it
7
.
In the case of tools with a shaft diameter of 4.5 mm and a square end of 3.4 mm (e.g. an M4 threading
tool), the square end in the collet is not used. The square end of the spindle
1
is used instead.
9.3 S-Former E1.1
9.3.1
Changing the tool
1
Spindle
2
Open-end spanner
SW10
3
Hook wrench
4
Tool
5
Clamping nut
1. Pull out the spindle
1
by hand.
2. Loosen the clamping nut by approx. 1 revolution
5
using the hook wrench
3
and fix the spindle
1
using an SW22 open-end spanner
2
.
3. Pull the tool
4
out of the collet by hand.
4. Insert the new tool into the collet by hand.
5. Slightly twist the tool until its square end locks into that of the spindle reducer (not visible here)
6. Retighten the clamping nut
5
.
1
2
3
4
5
Summary of Contents for S-Former E
Page 1: ...Assembly instructions for S Former E ...
Page 91: ......
