– 17 –
GB
Important:
Incorrectly wired connections will produce a short
circuit later on in the product or your fuse box. In
this case, you must identify the individual con-
ductors once again and reconnect them. A mains
power switch for turning the unit ON and OFF may
of course be installed in the mains supply lead
(in applications without emergency light module).
Important:
The light source of this light cannot be replaced. If
the light source needs to be replaced (e.g. at the
end of its service life), the complete light must be
replaced.
5. Mounting
• Check all components for damage.
• Do not use the product if it is damaged.
• When installing the light, make sure the installa-
tion site is not subject to vibration.
• Select an appropriate mounting location, taking
the reach and motion detection into consideration.
• The ventilation slots must not be obstructed after
installing the light.
Mounting procedure
•
Undo retaining screws (no need to remove the
retaining screws completely) and take off the light
enclosure
(Fig. 5.1)
•
Mark drill holes
(Fig. 5.2)
• Drill holes and insert wall plugs
(Fig. 5.3)
• Installation with surface-mounted power supply
lead
(Fig. 5.4)
•
Installation with concealed power supply lead
(Fig. 5.5)
• Connect conductors
(Fig. 5.6)
• Fit light enclosure and screw in place with retain-
ing screws
(Fig. 5.7)
•
Switch ON power supply
6. Function
Factory settings
Reach setting:
10 m
Main light time setting:
3 min.
Basic light time setting:
5 min.
Twilight setting:
500 lux
Basic light dimming level: 5%
Backlight: ON
The sensor function is activated in the factory
setting so that the light is directly ready for opera-
tion. To put the product into reference mode, go to
the technical documentation at: www.steinel.de.
To configure the light, you must download the
Steinel Connect App from your app store. You will
need a Bluetooth-capable smartphone or tablet.
Android
iOS
Reach adjustment
The reach setting can be infinitely varied between 1
and 10 m. Reach can be reduced in four directions
by fitting the slot-in shrouds included.
(Fig. 6.1)
Time setting
The main light's ON time can be set to any period
from 5 seconds to 60 minutes. Any movement
detected before this time elapses will restart the timer.
Twilight setting
The chosen response threshold can be infinitely
varied from 2 to 2000 lux.
Basic light level
The brightness of the basic light level setting can be
varied between 1% and 50%.
The period for which the basic light level stays ON
for can be infinitely varied between 10 minutes and
30 minutes, or set to remain ON all night.
Main light level
The brightness of the main light level setting can be
varied between 50% and 100%.
Backlight
(PLUS version)
The setting for switching the backlight ON or OFF
can be selected manually.
Constant-lighting control
(PLUS version)
If this function is activated, lighting will be set to a
constant level in natural daylight. If the surroundings
become darker, the light increases its light output, if
the surroundings become brighter, the light reduces
its light output.
