STEINEL Gluefix Gluematic 3002, Information

Page: 7 / 79

- 12 - - 13 -
L Attach wire stand and insert glue sticks
into the heating channel at the back.
L
Rest applicator on wire stand (placing
a piece of cardboard or wood under-
neath it if necessary).
L
Let the applicator heat up for approx.
7 minutes.
L Press trigger and apply glue to one side.
L Firmly press together the materials
being glued, correcting alignment if
necessary.
L Final bonding strength is reached after
a very short time (approx. 2 minutes)!
L Spot gluing is recommended on long
items with large surfaces.
L
Rigid foam (e.g. polystyrene) can also
be glued without a problem. Merely
remember to apply the hot glue on the
base surface and not on the polysty-
rene.
L When gluing textiles or similar materials,
it is recommended to apply the hot glue
in "wavy" lines.
L After use, set tool on stand
and let it cool down.
L Do not use liquid or pasty adhesives!
L The glue reaches temperatures of up
to 200 degrees Celsius! You could burn
yourself!
L
You could burn yourself. After skin
contact with hot glue: immediately cool
with cold water. Do not try to remove
hot-melt glue from the skin. If necessary,
seek medical attention. After eye contact
with hot-melt glue: immediately cool for
approx. 15 min. with running water and
consult a doctor straight away.
L
The area you are gluing must be free of
grease, dry and absolutely clean.
L Glue marks on clothing cannot be
removed.
L Make sure heat-sensitive materials are
suitable for gluing
L Drips of glue are best removed when
cold.
L
Do not pull the glue stick out of the
applicator. Hot glue running into the
applicator may cause damage.
L
Do not use in conjunction with highly
inflammable/combustible materials.
L Adhesive joints and glued areas can be
painted or varnished over and can be
taken apart again by heating them
L Always screw the nozzle tight after
replacing it (approx. 1 Nm).
L Proper operation is only guaranteed
by using genuine STEINEL sticks.
Important advice
Operation / Function
Repairs by a
qualified
electrician only
This electric power tool
complies with the relevant
safety regulations. Repairs
should only be performed
by a qualified electrician.
Otherwise the user may
run the risk of accidents.
If this tool‘s main power
cord is damaged, it must
be replaced by the ma-
nufacturer or its customer
service department or a
similarly qualified person
so as to avoid hazards.
Keep these safety
precautions with the
tool.
Applications for Gluematic 3002
Applications for Gluefix
L Making greeting cards
L Making hair accessories
L
Making floral wreaths and flower arrangements
L Making floral wreaths and flower arrangements
L Repairing wooden drawers
L
Making greeting cards
1. Nozzle (can be change on Gluematic 3002)
2. Trigger
3. Power cord
Tool features
Safety warnings
GB