Software
UR44C Operation Manual
11
8
REV-X Return Value
Displays and adjusts the REV-X Return value. Enable
editing of the value by double clicking the number.
MASTER Area
This is the area for configuring the master channel
settings.
1
Level Meter
Indicates the signal level.
2
Loop Back
Turns the Loopback function on (lit) and off (unlit). This
can only be used with MIX1.
3
Balance
Adjusts the volume balance of the left and right channels.
Range:
L16 − C − R16
4
Balance Value
Displays and adjusts the Balance value. Enable editing of
the value by double clicking the number.
5
Mute
Turn the mute function on (lit)/ off (unlit).
6
Master Fader
Adjusts the signal level.
Range:
-∞ dB − +6.00 dB
7
Master Fader Value
Displays and adjusts the Master Fader value. Enable
editing of the value by double clicking the number.
8
Headphones
Turns the two headphones output on (lit) or off (unlit). You
can output the MIX selected in the MIX area to the
PHONES by turning this on.
NOTE
With [PHONES 2], either MIX 1 or MIX 2 can be selected.
[PHONES 1] is fixed to MIX 1 and cannot be changed.
MIX Area
This is the area for selecting the MIX you want to
configure.
You can copy the Main window settings of the MIX by
dragging and dropping.
What is Loopback?
Loopback is a convenient function for broadcasting
over the Internet. It mixes the input audio signals (such
as microphone and guitar) with the audio signals
playing back in the software in the computer into two
channels in the UR44C, and sends them back to the
computer. Refer to the section “Signal Flow” (
If the Loopback function is on while you are monitoring
input signals from the UR44C via DAW software, it will
cause loud noise. This is because an infinite loop of the
audio signal is generated between the UR44C and the
DAW software. When using the loopback function, turn
off the monitor functions on your DAW software.
2
7
3
4
5
6
1
8
UR44C
BGM
Deliver
