Usage Examples
UR28M
Operation Manual
28
Usage Examples
Introduction
This section introduces some usage examples of
the device. It is assumed that the audio driver
settings on the DAW software have been properly
configured according to the “Basic Operation”
section in the Getting Started manual. If you have
not configured them yet, refer to the section “Basic
Operation” to complete the configuration.
Recording with the Channel
Strip and REV-X
This section shows how to record a vocal to DAW
software using the built-in Channel Strip and REV-X
on the device. When using Cubase series
programs, it is handy to use the project template.
These project templates include the settings of the
Channel Strip and REV-X. You can start recording
instantly by opening the project template. When
using programs other than the Cubase series, use
the dspMixFx UR28M.
Connection Example
Operation
Cubase Series Programs
1.
Launch the Cubase series DAW.
The Project Assistant window appears.
2.
Select the project template “Steinberg
UR28M Vocal-Inst Recording 1” in
“Recording” on the Project Assistant
window, then click [Create].
When using Cubase 7, select “Steinberg
UR28M Vocal-Inst Recording 1-C7.” The “C7”
designation in project template name indicates
the template is for Cubase 7 or later.
3.
Turn on Direct Monitoring as follows.
[Devices]
[Device Setup]
[Yamaha
Steinberg USB ASIO] (Windows) or [Steinberg
UR28M] (Mac)
enter checkmark to “Direct
Monitoring”
[OK]
4.
Confirm that the "Record Enable” and
“Monitor” indicators are turned on (lit) for
the audio track.
5.
While singing into the microphone, adjust
the input signal level of the microphone by
the INPUT GAIN knob on the device.
Adjust the input signal level so that the red
lamp in the INPUT meter does not light.
6.
While singing into the microphone, adjust
the output signal level of the headphones by
the PHONES knob on the device.
Computer
Monitor speakers
Headphones
Microphone
