Steinbach HJ1103, Original Owner'S Manual

Page: 23 / 185

Attaching the floating handle
1. Guide the end of the nylon cord of the floating
handle
6
through the eyelet on the top part
2
.
2. Shorten the nylon cord to a length that roughly
corresponds to the depth of your pool and tie it
in a knot.
The floating handle is attached.
Installing the brush
The brush
5
can improve the cleaning of your pool, depending on the conditions on site, such as type
and quantity of dirt or surface structure of the bottom. Only operate the device with the brush installed if
this leads to a better cleaning result.
1. Press the brush strip
5
into the indentation on
the bottom of the bottom part
4
.
2. Make sure that the brush strip
5
has
completely engaged and fits tightly.
The brush is installed.
Removing the brush
1. Unlatch the hook of the brush strip
5
from the inside and press the brush strip out of the bottom
part
4
at the same time.
2. Take out the brush strip
5
.
The brush is removed.
Operation
WARNING!
Do not operate while swimming! Mortal danger!
Hair or clothing can be sucked in or trapped by the cleaning element, hold persons under
water and, in extreme cases, prevent them from resurfacing.
-
Never operate the device while there are persons in the pool.
-
Prevent any access to the pool as long as the device is in operation.
Attach the floating handle so you can place the device in the pool and take it out of the pool in a
controlled manner.
4
6
2
5
4
5
23
en