Steinbach 040916, Original Owner'S Manual

Page: 28 / 210

3. Uninstall the pool lines and drain them.
4. Remove the drain screws
12
on the pump housing and completely empty the pump.
5. Screw the drain screws into the pump housing.
6. Thoroughly clean the device (see section "Cleaning").
7. Let the device dry completely after cleaning.
8. Store the device in a dry and frost-free location (>= +5 °C) without direct sunlight.
The device is stored.
Troubleshooting
Problem Possible cause Remedy
Air bubbles escape from the
injection nozzle or the pump emits
unusual noises. The pump is sucking in air. Check all hoses and gaskets for leaks.
Retighten the hose clamps.
Check the water level in the pool and fill
with more water if necessary until the
pool water covers the suction line
connection by approx. 2.5 - 5 cm (1 to 2
in).
The water level in the pool is too
low. Raise the water level in the pool.
The prefilter basket (if present)
is clogged. Empty the prefilter basket.
The suction line is out of place
or clogged. Clean the suction line.
After the pump has been switched
on, the timer LED does not flash
and the pump does not start up. The pump has no power. Connect the pump's power plug to the
power supply. Check whether the fuse
has tripped.
The pump is defective. Contact customer service.
The pump is not running. The timer is set. Press the timer button. The running time
can be set when the pump is switched off.
Turn on the pump.
The external timer is set. Check the running times on the external
timer.
If the problem cannot be solved, contact the customer service listed on the last page.
28