RC Instruction Manual
11
Ratchet Strap Mounting
Base Anchor Point
The Working Load Limits (WLL) are based on using the specified
mounting Ratchet Strap and backed up with a sufficiently rated
Anchor Sling. This is to be connected directly to the base anchor point
as shown in the diagram below using a chocked hitch and terminated
around the tree using a suitable self-tightening hitch such as a
cow-hitch or timber-hitch.
This must be inspected & checked for both tension and wear after
each lowering/lifting operation to ensure it is securely attached to the
device and the mounting point.
Anchor Sling
Top Attachment Point
The top attachment point has a
Working Load Limit (WLL) of
100kg. This can also be used to
support the weight of the device
to help with the initial mounting by
an individual person and with the
removal of the device from the
mounting point.
(5)
(6)
WARNING:
The RC Device should never be operated
or used without an Anchor Sling fitted and
secured properly using an appropriate knot.
Top Attachment Point
(1)
(2)
(3)
(4)
When fixing either end of the Ratchet Strap ensure the hook faces outwards as in diagram (1) and is pulled
horizontal. By fitting the Ratchet as pictured in diagram (2) the hook could slip out during use. Never pull the
Webbing Straps at an angle as shown in diagrams (3) & (4).
When tightening the ratchet ensure the webbing enters the ratchet evenly (5) and is not in contact with the
side guide plates (6). This will cause premature wear to the webbing and possible webbing failure. The
retention devices must be inspected & checked for both tension and wear after each lowering or lifting
operation to ensure they are securely attached to the RC device and the mounting point.
