STEERIX-RC.COM
1
2
18005
Battery Installation
Installing the 9V Battery in your
Transmitter
1. Make sure the transmitter ON/OFF
switch is in the “OFF” position.
2. Remove battery cover screw.
3. Remove battery cover by pressing
down on the embossed arrow and
sliding the cover as indicated.
4. Insert the 9V battery, paying close
attention to the + and - polarity.
5. Slide the battery cover back into place.
6. Replace battery cover screw.
NOTE: Remove the 9V battery from the
transmitter if you do not intend to
use it for an extended period of
time.
Installing the 6V NiMH Battery in
your Boat
(Model should be placed on its supplied
boat stand to prevent damage to the
running hardware.)
1. Remove the hatch by pulling
carefully on the catch at the rear
section.
2. Insert the 6V battery into the left side
of the hull.
3. Insert the 6V battery connector into the matching connector inside the STRX-9. DO
NOT force them together.
4. Replace the hatch.
NOTE: 1. There is a rubber ring placed along the slot of the hull. Always make sure it is
secured properly before re-positioning the hatch.
2. When you are not using the boat, also unplug the battery and remove the
rubber ring from the hull. This will keep the rubber ring flexible and provide
effective water-resistance for future use.