5
2
TURNTABLE OPERATION
1.
Rotate the
ON-OFF VOLUME SWITCH
located on the front panel to switch the unit ON.
2.
Release the
TONE ARM
from the
ARM LOCK
and place it on the
ARM REST
.
Important Note: The ARM LOCK is taller than the turntable and needs to be folded down
to allow larger records to be played.
3.
Set the
SPEED CONTROL SWITCH
to the desired speed (33
1
/
3
or 45 rpm).
4.
Place the record on the turntable*.
5.
Lift the
TONE ARM
and move it by hand to the record - the turntable will start turning
automatically - then slowly lower it onto the desired starting point.
Note:
At the end of the record, the turntable will still be rotating. You must lift the
TONE ARM and return it back to the ARM REST manually.
6.
Re-adjust the
ON-OFF VOLUME SWITCH
to the desired sound level and rotate the
TONE
control knob as required.
Note
: After use and removing the record, always push the
ARM LOCK
upwards again before
placing the
TONE ARM
back on it – then lock it and close the cover.
*Accessory: Spindle Adaptor for 45rpm records
Note:
The spindle adaptor disc is stored on the turntable deck and s
hould only be used if the centre clip on the 45rpm record is missing!
1.
Place the 45rpm adaptor on the spindle before placing the record
on the turntable.
2.
Place your 45rpm record onto the turntable.
3.
Follow the steps under
TURNTABLE OPERATION
to play your record.
NEEDLE REMOVAL & INSTALLATION
The record player is already fitted with a universal needle (or stylus) suitable for playing 33
1
/
3
and 45 rpm records. The procedure for removing and re-fitting the needle is as follows:
REMOVING THE NEEDLE HOLDER (OR STYLUS)
Gently pull down the tip of the stylus holder (1).
Pull the cartridge forward (2). Pull it out and remove it from the tone arm head (3).
FITTING A STYLUS CARTRIDGE
After following the “Removing the Needle Holder” instructions above, follow steps 1 to 4 below
to refit it:
1.
Position the red stylus holder with the Sapphire stylus tip facing down.
2.
Line up the tab at the back of the stylus holder with the tone arm cartridge (see picture 1).
3.
Insert the stylus holder with its front end at a downward angle (see picture 2 below).
4.
Lift the front end of stylus holder upward until it snaps into place.
LOCATION OF PARTS
SPEAKERS
SPEAKER IN JACK
ON-OFF SWITCH /
VOLUME CONTROL
TONE
CONTROL
TONE
VOLUME
ON/
OFF
1
2
3
2
1
2
3
TURN UPWARDS
