SM-BM-16
SM-BM-
16 Operator’s Manual
11
3.3. Adjusting the guide for beveling with radius
Unplug the machine from the power source. Loosen the clamping screw and rotate
the sleeve to put the surface (
1
)
on the same level as the
radial
cutting
edge
(
2
). You
can also use an optional radius insert positioner to set the guide correctly. Next,
tighten
the
clamping screw. Then, bevel a test edge and if necessary adjust the
position of the guide again.
3.4. Preparing
Install a milling head with the cutting inserts, and set the required bevel parameters.
Then, use the speed dial to set the speed that matches the type of the workpiece
(Tab. 2).
Material type
Rotational speed
Aluminum, brass, plastics
Setting 6 (5850 rpm)
Structural steel of standard quality, quality steel
Settings 3
–5 (3100–4500 rpm)
Tab. 2.
Recommended rotational speeds
The speed dial allows continuous control of the rotational speed in the range of
1800
–5850 rpm.
Setting
1
2
3
4
5
6
Speed
1800 rpm
2400 rpm
3100 rpm
3800 rpm
4500 rpm
5850 rpm
To machine structural steel of standard quality or quality steel, set the speed to
4
and decrease the speed if much sparking occurs.
2
1
