SM-S-9 XP Operator’s Manual
- 18 -
2017 Version 1.01
Using the LED Light
The LED ligth is used to illuminate the cutting area
when working in low light conditions. Turn the LED
light on by pressing the right switch (A) on the saw
handle. Press the switch again to turn off the LED
light.
Fig. 14.
Cutting Depth Adjustment
1.
Loosen the lock lever (A) to loosen the base plate.
Fig.15.
2.
Lift the back of the saw away from the baseplate
until the desired depth of cut is achieved.
3.
Securely re-tighten the lock lever (A) after the
depth adjustment is made.
Fig. 16.