HAMMER DRILL 1/2”
Assemble and Operating instructions
Certificate Number: E222615
GRNERAL SAFETY INSTRUCTIONS
WARNING! Read and understand all instructions. Failure to follow all instructions listed below may
result in electrical shock, fire and/or serious personal injury.
SAVE THESE INSTRUCTIONS
WORK AREA
~
Keep your work area clear, clean and well lit. Cluttered work surfaces and dark areas invite accidents.
~
Keep people not involved in the work, especially children away from the work area while operating a
power tool. Distractions can cause you to lose control of the tool.
~
Do not operate power tools in an unsafe environment such as explosive atmosphere, flammable
liquids, gases and dust. A spark created by a power tool may ignite the fumes or dust.
ELECTRICAL SAFETY
~
Double insulated tools are equipped with a polarized plug(one blade is wider than the other.) This plug
will fit into a polarized outlet only one way. If it does not fit fully in the outlet, reverse the plug and try
again. If it still does not fit fully, contact a qualified electrician to install a polarized plug. Do not modify
the plug in any way. Double insulation eliminates the need for the three wire grounded power cord and
grounded electrical system.
~
Avoid body contact with grounded surfaces such as radiators, pipes ranges and refrigerators. There is
an increased risk of electrical shock if your body is grounded.
~
Do not operate power tools in the rain or wet conditions. Water entering a power tool increases the
risk of electrical shock.
~
Do not stress the power cord. Never carry the power tool by the cord or disconnect the plug from the
receptacle by yanking on the cord. Keep cord away from sharp edges, heat, solvents and oil.
Replace damaged cord immediately. Damaged cords increase the risk of electrical shock.
~
Use outdoor extension cords when operating the power tool outside .Outdoor power cords are marked
"W-A" or "W" and are rated for outdoor use. These cords reduce the risk of electrical shock.
PERSONAL SAFETY
~
Dress appropriately. Do not wear loose clothing or jewelry. Keep long hair in place and contained.
Keep clothing, hair and gloves away from moving parts. Loose clothing, jewelry and hair can be
snagged in moving parts.
~
Use common sense, stay alert and watch what you are doing while operating a power tool. Do not
use tools while under the influence of alcohol, medication, or drugs. Keep focused on the work at hand
while using a power tool to prevent personal injury.
~
Make sure the power switch is in the "OFF" position before plugging it into the receptacle.
This will prevent accidental starting. Carrying tools with your finger on the switch or plugging in the
tools with the switch in the “ON” position invites accidents.
~
Remove adjusting tools such as wrenches or keys before turning the tool on. A wrench or key left
attached to a rotating part will fly off and may cause personal injury.
Summary of Contents for SP-PT237
Page 1: ...SP PT237...