ELEVATION BULL NOSE FRONT BUMPER
2009-14 FORD F150
Page 3 of 7
13.
Level and adjust the bumper and fully tighten all 12mm hardware to 65-70ft-lbs.
Access hardware at the
top of the Mounting Bracket through the removable access cover on the top of the Bumper.
NOTE
: If
additional adjustment is required, loosen Frame Bracket Hardware and adjust Bracket as necessary.
14. Models with fog lights
:
a.
Remove both fog light assemblies from the back of the original bumper,
(Figure 16)
.
b.
Line up the driver side fog light assembly with the (3) mounting tabs welded onto the back of the
bumper. Attach the fog light assembly to the tabs with the included (3) 6mm x 25mm Hex Bolts, (6)
6mm Flat Washers and (3) 6mm Nylon Lock Nuts,
(Figure 17)
. Mounting tabs may move during
shipping. Use hand tools to carefully adjust mounting tabs to line up flat with plastic fog light
housing.
IMPORTANT
: Do not overtighten 6mm hardware attaching fog light to Bumper or plastic
housing may be damaged.
c.
Repeat to install the passenger side fog light assembly.
d.
Reattach the factory wiring harness to both lights.
15.
Use the included (2) push-in plastic nuts to attach the front license plate, (if required), to the (2) holes in
the front bumper,
(Figure 18)
.
16.
Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment
, wax this product after installing. Regular waxing is recommended to add a protective layer
over the finish. Do not use any type of polish or wax that may contain abrasives that could damage the finish. Mild soap
may be used to clean the Front Bumper assembly.
Driver Side Installation Pictured
Front
WARNING!
Do not remove bumper bolts
unless the bumper is properly supported on
blocks or stands or the bumper may fall.
(Fig 2) Remove factory hex nuts
(arrows) from back of bumper bracket
(Fig 3) Remove air dam from
bottom of frame (if equipped)
Front
(Fig 1) Remove screws attaching hood latch
to bracket and bracket to bumper (arrows)
Front
