Page 3 of 4
939504576 Rev H
Right Side
Step 6 Unlocked
Position
Step 7 Locked
Position
1/16"
step 7 Locked
step 7 push
step 6 Unlocked
step 6 Unlocked
step 7
Locked
Sli
de
Sli
de
INWARD
OUTWARDS
1/16"
Left Side
Step 6 Unlocked
Position
Step 7 Locked
Position
INWARD
OUTWARDS
Illustration #5
(back of skin)
Middle
Attachment
Bracket
Adjustment
Lever
Illustration #4
step 7 push
6.
Only for "C" Slatwall Skin.
5.
"A" size go to Step #11
Rotate the Slatwall Skin down. From the front of the skin
slide the middle attachment bracket towards the center
of the skin until the bracket is engaged into the skin
attachment slot in the frame. This is the unlocked position.
See illustration #3 & #4.
NOTE:
1. Use a non-marring tool to slide the bracket.
(See modified plastic packaging corner from 2" or 4"
segment frame on page 4.)
2. AVOID USING FORCE to engage bracket. Refer
to Steps 9 and 10.
7.
Once the bracket is engaged into the frame, slide
the middle attachment bracket towards the outside edge
of the skin while forcing the skin flat against the frame
rail until the bracket slot and the skin slot are within
approximately 1/16" as shown. This is the locked
position. See illustration #4.
8.
Check to make sure that the bracket is engaged into
the slot in the frame by pulling in the center of the skin.
maximum bow allowed is approximately 1/16".
9.
If the bracket does not engage into the slot in the
frame, an adjustment to the lever on the back of the
skin may be necessary. See illustration #5.
10.
Manually lift or lower the adjustment lever into a
position that the bracket will engage into the slot in the
frame. See illustration #5.
NOTE: Adjustments cannot be made except by using
the lever. The fasteners that hold the bracket and lever
in place must not be tightened or unfastened at any
time. See illustration #5.
step 10
