Steelcase Montage Wood Selections Assembly Directions Download Page 4

Page: 4 / 4

Page 4 of 4

Steelcase

ATTACH SOCK TOP OR SCOOP TOP WORKSURFACE TO PANEL

USING END SUPPORT BRACKET AND SHARED CANTILVER

BEND

TAB DOWN

BREAK

TAB OFF

Break

bend

tab on corner

support bracket and

tab on cantilever

bracket as shown.

Attach bracket to cantilever

and insert support bracket.

Lower worksurface onto

supports and secure with

screws provided.

Height may be adjusted

by turning column.

Y9501922 Rev.

Summary of Contents for Montage Wood Selections

Page 1: ...ons Rev D Bullet Top Worksurfaces P Top Worksurfaces Sock Top Worksurfaces Scoop Top Worksurfaces BULLET TOP WORKSURFACE Refer to page 2 P TOP WORKSURFACE Refer to page 3 SCOOP TOP WORKSURFACE Refer to page 4 SOCK TOP WORKSURFACE Refer to page 4 GAP GAP GAP GAP IMPORTANT Be certain to maintain a 1 8 3 2mm gap between worksurfaces ...

Page 2: ...oft clean surface Attach base assembly Break tab on corner support bracket and bend tab on cantilever bracket as shown Attach bracket to cantilever and insert support bracket Lower worksurface onto supports and secure with screws provided Height may be adjusted by turning column Use predrilled holes in underside of top Y9501922 Rev D 1 1 BEND TAB DOWN BREAK TAB OFF ...

Page 3: ...3 of 4 Steelcase TO ATTACH WORKSURFACE TO ANOTHER WORKSURFACE AT 90 Locate brackets on underside of worksurfaces as shown Secure brackets with screws provided Height may be adjusted by turning column BOTTOM VIEW FLUSH MOUNT BRACKETS Y9501922 Rev D ...

Page 4: ...ED CANTILVER 1 1 BEND TAB DOWN BREAK TAB OFF 1 2 3 4 Break bend tab on corner support bracket and tab on cantilever bracket as shown Attach bracket to cantilever and insert support bracket Lower worksurface onto supports and secure with screws provided Height may be adjusted by turning column Y9501922 Rev D ...