Page 3 of 4
939502116 Rev C
IV Pole Installation
NOTE: You will need to cut the holes in the
fabric. We recommend a hole punch tool that is
3/8" diameter. (McMaster-Carr, Osborne, etc.)
1.
Mark the two (2) hole locations as shown.
FOR MINERAL ONLY:
2.
Verify location by using a pin, find the
center of the treaded inserts that are
pre-installed in the frame under the fabric at the
two (2) marks made in step 1.
3.
Now that you know where the center of the
threaded inserts are, push and rotate the hole
punch tool in the center of the verified hole
location to cut through the fabric down to the
steel. Remove the cut piece of fabric.
4.
Install IV pole bracket with two (2) pan head
screws (provided) with hex allen wrench.
MITRA ONLY:
2.
There are no inserts behind the fabric. Push
and rotate the hole punch tool in the center
(same as step 3 above) and remove the cut
piece of fabric. (This is done so the installer will
not stretch the fabric when installing the
screws.)
3.
Install IV pole bracket with two (2) flat head
wood screws (provided) with phillips
screwdriver into the wood side frame.
3-1/2”
1-3/8”
5-5/8”
5-5/8”
2
1
3
4
Mitra Recliner
Mineral Recliner
(Back View)
3-11/16”
4-1/2”
PIN
HOLE
PUNCH
TOOL
IV POLE
BRACKET
PAN HEAD
SCREW
