Assembly Directions
93-9500971 REV A
Page
5 of 5
6.
Insert (2) angle clips into hanger bracket. Then
insert (2) 1/4-20 machine screws. Do not
tighten at this time.
HOLES “A”
7.
Place open end of return unit top on hanger
bracket, checking for proper alignment. Mark
holes. Remove return unit and drill (3) 5/32”
dia. holes.
8.
Replace return unit on desk, checking for proper
alignment. Tighten the clip angles to top. Insert
(3) 1/4 x 1” hex head screws into holes “A” and tighten.
NOTE: For wood top omit clip angle assembly.
1/4 x 1”
HEX HEAD
SCREWS
CLIP ANGLE
1/4-20
MACHINE
SCREW
HANGER
BRACKET
9.
Bottom panel plate return unit to desk installation
Remove bottom drawer from your desk. Then secure bottom
panel plate
(NOTE: See figure “b”, page 3for correct plate)
to desk with (2) #10 x 1/2” sheetmetal screws and
(1) twin speednut. Assemble drawer back into desk.
10.
Secure bottom flange of back panel to bottom
panel plate with (2) #10-24 x 3/8” machine
screws and hex nuts.
BACK PANEL
HEX NUT
SPEEDNUT
#10 x 1/2”
SHEETMETAL
SCREW
#10-24 x 3/8”
MACHINE SCREW
BOTTOM
PANEL PLATE
