Steel City TITANIUM 50-550, Owner'S Manual

Page: 10 / 40

Page 10
◊ CLEANING
Anticorrosive oil is applied to the machine before
shipment. It can be removed by using WD40 on the
coated parts and wipe it off with a soft cloth. This may
be done several times before the coating isremoved
completely. Do not use lacquer thinner or other volatile
solvents, as they can damage the surface of the
machine.
◊ ELECTRICAL INSTALLATION
Electrical wiring should be done by a qualified
electrician.The machine must be properly grounded to
avoid electric shocks and associated hazards.
◊ COMPRESSED AIR
Compressed air is used to control the belt tension and
oscillation. A clean air source must be connected to the
air inlet on the regulator.
NOTE: the machine will not run if air pressure is
not sufficient.
Pull the regulator knob up to unlock and rotate it,
clockwise to increase, counter-clockwise to decrease,
until pressure is set to about 75-80 psi. Press the knob
down to lock it.
◊ DUST COLLECTION
CAUTION:
This machine creates a lot of dust during operation.
Make sure to use adequate dust collector and wear
appropriate respiratory/dust mask if required.
This machine should use a dust collector providing
adequate capacity for the 6 dust ports of 5’’. The
capacity must take into account branches, elbows and
other connections in the network.
The 6 dust ports are located on top of the machine. The
hoses must be secured to the ports by mean of hose
clamps.
INSTALLATION
NOTE: Always turn on the dust collector before
operating the sander.
WARNING
!
Make sure the switch is in the off position and
the machine is unplugged.