Steel City 50126SC, User Manual

Page: 17 / 34

ATTACHING BAND SAW TO BASE
1. Place the bandsaw on top of the base making sure
to line up the four holes in the base with the four
Holes in the casting of the bandsaw.
NOTE: When placing the bandsaw on the base, make
sure that the exposed pulley (A) and the cutout (B) in
the base are on the same side.
SEE FIG. 5.
2. Fasten the bandsaw to the base using four M8
x40mm Hex head screws, four M8 flat washers, and
four M8 lock washers.
17
INSTALLING BELT
AND BELT GUARD
1. Install Belt by “walking” the belt onto the Band saw
Pulley (B) and the Motor pulley (C). SEE FIG.6
FIG.5
FIG. 6